Owner's Manual

Restore Default Settings

173

Appendix

The reset switch is located in a recessed area. Push

the switch using the tip of a slender object such as a

clip.

All settings of the camera, except for the date and

time, are restored to factory default settings.

For dome case attachment, see the “Installation

Guide” included with the camera.

Turn on the power while pushing the reset switch, and

keep pushing the reset switch for 5 seconds or more.

Important

If the reset switch is pushed, network-related settings will also

be restored to factory default settings including the camera's IP

address, subnet mask, default gateway address, etc.

Accordingly, you can no longer operate the camera from the

PC you were using to connect to the camera before. When

initializing the camera, use the “VB Initial Setting Tool” installed

in your PC to set an IP address appropriate for the environment

in which the camera is used (See “Performing Initial Settings for

the Camera” (p. 28)).

Reset Switch

VB-H630VE/VB-M620VE

Reset Switch

For VB-H630VE/VB-H630D/VB-M620VE/VB-M620D,

attach the dome case.

VB-H630D/VB-M620D

Reset Switch