Operation Manual

Network settings for connecting to the camera.

LAN

Set the LAN communication method and size of video transmitted from the camera.

[LAN Interface]

Select the interface suited to the device for connecting to the camera. Generally use [Auto].

[Maximum Packet Size]

Enter the maximum packet size to be transmitted by the camera. Normally there is no need to change the default setting of

1500.

A setting of 1280 or greater is necessary when using IPv6.

When using ADSL, setting a slightly lower value may increase transmission efficiency.

IPv4

Settings for using IPv4 to connect to the camera. The IPv4 address can be assigned by the DHCP server automatically or

set manually.

[IPv4 Address Setting Method]

Select the method for setting the IPv4 address.

Configure Network Settings

[Basic Settings] > [Network]

Important

If any network settings are changed, the camera may become inaccessible from the active web browser. If this occurs, a confirmation

dialog box will appear when you click [Apply] or [Apply and reboot]. Click [OK] to apply the new settings.

If you reboot the camera after changing settings and cannot connect to the camera from the web browser, any available URI for

connecting to the camera will be displayed in a message. If you cannot connect to the camera through the displayed URI, contact your

system administrator.

Important

• Contact your System Administrator for the [IPv4 Address], [Subnet Mask] and [IPv4 Default Gateway Address] if you set the IPv4

address manually.

• If any of the [IPv4 Address], [Subnet Mask] or [IPv4 Default Gateway Address] settings are wrong, the camera may become

inaccessible via the network. If this occurs, use the Camera Management Tool to reset the address (P. 36).