VB-M600VE Operation Guide

[Network] Setting Administrator Password, LAN, IP Address, DNS, etc

5-7

Setting Page

SNMP

1 [SNMP]

Set SNMP use to [Disable] or [Enable]. Camera

information can be referenced by the SNMP Manager if

[Enable] is specified.

2 [Community Name]

Set a community name for SNMP. It is recommended

that you change the community name to ensure system

security.

3 [Administrator Contact Information]

Set contact information (e-mail address, etc.) for the

Administrator of the camera. Setting information can be

referenced by the SNMP manager.

4 [Administration Function Name]

Set the camera name used for administration. Setting

information can be referenced by the SNMP manager.

If left blank, “VB-M700” will be used by default for VB-

M700F and “VB-M600” will be used by default for VB-

M600D/VB-M600VE.

5 [Installation Location]

Set information regarding the installation location of this

camera. Setting information can be referenced by the

SNMP manager.

Note

• The information set in the camera is read-only from the SNMP

manager.

• Use the SNMP Manager that supports SNMP MIB2 (supporting

RFC1213).

• Supports SNMP protocol versions v1 and v2c (v3

unsupported).