Operation Manual

Appendix
7
271
Prepare the camera for being reset in advance.
In order to press the reset switch or restart switch, it may be necessary to remove such items as the dome case or cover.
For details, please refer to the “Installation Guide” included with the camera.
(VB-R11VE)
When the LED stops flashing, the reset procedure is complete.
Important
When a camera is initialized by pressing the reset switch, all network related settings including the camera IP address, subnet mask, and
default gateway address are restored to the default settings so you will not be able to continue operation from the computer that was
connected. Use Camera Management Tool to set a suitable IP address for the operating environment (P. 37).
R11 R10
M641
M640
M741
M740
1
Hold down the reset switch while pressing the restart switch with a pointed object.
2
Release the restart switch after at least 3 seconds while still holding down the reset switch.
3
Release the reset switch when the LED starts flashing.
VB-R11VE/VB-R10VE
VB-M641V/VB-M640V
VB-M641VE/VB-M640VE
VB-M741LE/VB-M740E
Restart Switch
Reset switch
LED
Restart Switch
Reset switch
LED
Restart Switch
Reset switch
LED
Restart Switch
LED
Reset switch