Network Video Recording Software RM Series Administrator’s Manual

52
Note
• Items (1) to (4) can only be changed if the camera is disabled
using [Disable Camera].
• If a camera is not working, you can disable it to prevent
communication error notifications from being sent repeatedly.
• If you replace a camera that is not working with another
camera, change the new camera’s host name, etc. to that of
the non-working camera so there will be no effect on existing
recording schedules and settings. (The replacement should be
the same model as the original camera.)
 Change the Thumbnail Image of a Camera
You can change the thumbnail image of a camera.
In the camera properties dialog box, click the [General]
tab and click [Update] to display the [Thumbnail] dialog
box.
(1) Preview video
Drag the slider to change the zoom position of the
camera. Click in the preview video to change the
camera position.
(2) [Select Preset]
Select a preset made with the camera.
(3) [Update]
Use the current preview video as the camera
thumbnail image. The [Thumbnail] dialog box closes
and the camera thumbnail image is updated.
(4) [Cancel]
Close the dialog box without updating the thumbnail
image.
You cannot use the pan/tilt/zoom feature.
You cannot use the pan/tilt feature.
Presets cannot be selected.
You cannot use the zoom feature when the digital zoom is
set to [Disabled] on the camera.
Note
You must configure the presets first before starting operation. For
details, see the camera manual.
Remove a Camera
(1)
(2)
(3)
(4)
1
Select a camera in the list of cameras on the
[Cameras] tab.
2
Click [Remove].
3
A message is displayed asking if you want to remove
the camera. Click [Yes].
Important
If you remove a camera, you will no longer be able to play back
recordings made with the camera. If you need to play back the
recordings, use [Disable Camera] on the [Advanced] tab
instead of removing the camera.