Operation Manual

Adjust the camera angle when installing the camera or after changing the installation location.

The camera angle settings are configured by accessing the Setting Page (P. 76).

Step 1 Configuring the Camera

Set the digital zoom and video flip, which affect the camera angle.

[Digital Zoom] (P. 96) in [Camera] > [Camera] > [Camera Control] on the Setting Page.

[Video Flip] (P. 98) in [Camera] > [Camera] > [Installation Conditions] on the Setting Page.

Step 2 Setting Zoom

Set the zoom position with the zoom slider.

[Camera] > [Initial Settings] (P. 99) on the Setting Page.

If you set [Digital Zoom] to [Enable] in [Camera] > [Camera] > [Camera Control] on the Setting Page in Step 1, the digital

zoom area (yellow) is displayed and digital zoom becomes available.

The higher the digital zoom ratio, the lower the video quality becomes.

Step 3 Setting the Focus

You can manually focus on the subject, or fix the focus at infinity. When manually operating the focus, you can use the One-

shot AF feature to focus on the subject.

[Camera] > [Initial Settings] > [Camera Settings] > [Focus] (P. 101) on the Setting Page.

Note

For precautions, etc. regarding the focus, please refer to the “Important” and “Note” sections of [Camera] > [Initial Settings] > [Camera

Settings] > [Focus] on the Setting Page (P. 101).

Flow for the Setting of the Camera Angle

Important

If you change the zoom after configuring the intelligent function, privacy mask, preset, and ADSR, those settings must be configured

again.

H730

Digital Zoom Range

H730