User`s manual

Troubleshooting
6
98 99
Message
Explanation
●S001 Ethernet interface initialization failed (crit)
eci: netif can't up
Network interface initialization failed.
Response
If rebooting does not resolve the problem, contact an authorized Canon service representative.
Message
Explanation
●S002 Ethernet route registration failure (err)
eci: net route can't add
An attempt to register a route for a local Ethernet segment failed.
Response
Correct the Ethernet settings and reboot.
Message
Explanation
●S003 Ethernet default route registration failed (err)
eci: default route can't add
Registration of the default Ethernet route failed.
Response
Correct the Ethernet settings and reboot.
Message
Explanation
●S006 IP address conflict detection at startup (err)
Detected a conflict for IP address %1 with %2
An IP address conflict was detected during startup. If there is a device running on the network that
has the same IP address as the VB101, this error occurs when the VB101 starts up.
%1
IP address
%2
Ethernet address
Response
Change the VB101 IP address or change the IP address of the conflicting network
device. If you change the VB101 IP address, the VB101 must be rebooted.
When there is an IP address conflict, it may not be possible to modify the settings
via Ethernet. In this event, an initial setup tool must be used to change the settings.
Message
Explanation
●S007 IP address conflict detected during operation (err)
Duplicate IP address %1
An IP address conflict was detected during operation. This occurs when a network device
with the same IP address as the VB101 is started up after the VB101 was started up.
%1
Ethernet address
Response
As for S006.
Message
Explanation
●S010 FAT (File Allocation Table) count error (err)
only 2 FATs are supported (FATs=%1)
The number of FATs is not 2.
The file system may be corrupted or it may not be formatted as a FAT file system.
%1
Number of FATs
Response
If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
Message
Explanation
●S011 Cluster size error (err)
cluster size is zero
The size of clusters is zero.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response
If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
Message
Explanation
●S012 Sector size error (err)
logical sector size is zero
The sector size is zero.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response
If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
Message
Explanation
●S013 FAT entry count error (err)
file system has %1 clusters, but only space for %2 FAT clusters
The FAT entry recording area for the number of clusters is not allocated.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response
If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
%1
Number of clusters
%2
Number of FAT entries
Message
Explanation
●S014 Root directory size error (err)
root directory size is zero
The root directory size is zero.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response
If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
System-related Log Messages
Log Messages Log Messages
Message
Explanation
●S004 System startup (info)
System started
The VB software started up.
Message
Explanation
●S005 System settings changed (info)
System settings updated
The VB software settings were modified without a reboot.