Instruction manual

Communications

The RS-232 communication speed can be set to 4800, 9600 or 14400 bps

(bits per second). To adjust the speed, select the arrow next to the

default value (9600) and choose a different speed from the drop menu

and choose ‘OK’. The bps dip switch setting* of the VC-C3 should be

the same as what is set in the software. Consult your computers’

manual for the speeds your computer supports.

*Dip switch setting – Below is the table for setting the communication

speed on the VC-C3 Camera. Make sure the VC-C3 is powered OFF

and then move the switches to the desired position. The Diagram

shows the default position of all switches.

If the DIP switch setting on the CCU and the setting you chose in the

Communications Baud rate window are different you will get the

following error: