User`s manual

Camera Server Setting
2
33
Setting Up the Camera Server
Selecting the Settings
1
2
Setting the Limits for Connection to the Camera Server
Setting the Remote Maintenance Usage Conditions
Item
Enable remote
maintenance
OFF
Details Default Value
Specifies whether maintenance functions from a remote
computer can be used. If you place a tick in this checkbox,
remote maintenance functions are permitted. When remote
maintenance is permitted, the "Restrict clients" option is
enabled.
None
Sets the valid bits for IP addresses to which connection is
permitted. Bits for which "0" is specified as the mask are
ignored during checking.
Address Mask
None
Sets the IP addresses to which connection is permitted. Up to
20 addresses can be specified. A typical specification format
is "192.168.100.10".
IP Address
None
Sets the password used to authenticate the connection when
the "Permit remote maintenance" checkbox is ticked.
Password
OFF
Uses IP addresses to set the client access limits applied to the
WebView Livescope manager. Putting a tick in this checkbox
enables client limits to be applied.
Restrict clients
In the "Connection Limitation" setup window, click the
"Remote Maintenance" tab.
■ "Remote Maintenance" Settings
To perform remote maintenance, put a tick in the
"Enable remote maintenance" checkbox and set a
password. This setting then allows camera operations to
be managed from a remote computer.
Adding the "Restrict clients" setting means that remote
maintenance can only be performed from a machine with
one of the specified IP addresses.
3
a
IMPORTANT
a
IMPORTANT
After you have changed the settings, click the [OK] button.
To discard the changes, click the [Cancel] button.