User`s manual

Camera Server Setting
2
37
Setting Up the Camera Server
Selecting the Settings
1
2
Changing the Capture Card Settings
This option allows you to change the settings for your video capture card.
If you display the "[server name] (Local Server)
Setup" window and double-click "Capture Card",
the window for the capture card currently being
used appears.
Double-click the capture card name.
The setup window for your capture card appears.
There are no settings for the current version of
the Meteor, Meteor-PPB and Meteor-II capture
cards. The screen shown at left is displayed for
the Osprey-100 capture card. You can set the
capture method in this screen.
"Streaming Capture Mode" generally provides a
high frame rate but can place a high load on the
computer's CPU. "Frame Capture Mode" avoids
high loads on the CPU but does not generally provide as high a frame rate as streaming.
After you have changed the settings, click the [OK] button.
To discard the changes, click the [Cancel] button.
e
Note
Notation Correspondence (on-screen names and the corresponding correct card names)
Note that the type of card can only be changed if the capture card driver is installed.
a
IMPORTANT
c
Caution
Using the Osprey-100
The default capture mode is "Streaming Capture Mode", but this may place a high
load on the CPU when the frame rate is high (eg. 30 fps). In this event, change the
setting to "Frame Capture Mode" or use a lower frame rate.
On-screen Name
Matrox Meteor
Correct Card Name
Matrox Meteor-
ViewCast.com Inc. Osprey-100
Meteor, Meteor/PPB
Meteor-
Osprey-100
You can change the type of card used to capture video (only possible in local
maintenance).
➀ Click the capture card name and then click the [Change] button.
➁ Click the driver name to be used and then click the [OK] button.