Specifications

Authored by Simon Adams Product Support Specialist Canon UK RCC December 05

Revision 1.2 © Canon 2006

You will now need to set up your Access point, we will be setting up a Netgear WG602 here, however

the settings should be similar on other makes of access point, however you may need a different IP

address to get to the access point’s administration screen, so refer to your access point’s manual for this.

The Netgear’s administration screen is located at 192.168.0.227, so we will open an internet explorer

window and type the IP address into the URL bar. You will need to login to your access point (consult

your access point’s manual for the username and password)

Firstly set the IP address of your Access Point. This will be the “Gateway” setting that you enter later.

Here we have left the Netgear default setting of 192.168.0.227. Disable DHCP and ensure the subnet

mask is set to 255.255.255.0 and the gateway address is set to 0.0.0.0. Set your Access Point Name

here too, although ensure it is in capital letters, as this will form your SSID which is case sensitive. If

incorrect case is used for the AP name and the SSID on either the AP or the WFT-E1A you will not be

able to communicate between the two