Specifications

Authored by Simon Adams Product Support Specialist Canon UK RCC December 05
Revision 1.2 © Canon 2006
47
Stage 3 – Setting up the WFT-E1A using the WFT-E1A Utility
Load the utility from the Canon WFT-E1A disc.
In the first tab TCP/IP, select “Use the following IP address” and enter an IP address here which will
identify the WFT-E1A to the network. Ensure this address is not used by any other network device. We
have used 192.168.0.50 here. The subnet mask should be set to 255.255.255.0 as only the last set of
numbers will change on the network.
As we are using an access point in infrastructure mode, we need to specify the access points IP address
as the Gateway. Enter your access points IP address in the gateway field. DNS servers are not required
so we have left this blank.