User manual

Once an item is selected, it is converted into a variable string and placed
in the home directory field. You can modify this string to add additional
variables or static directory paths to customize the setup as desired.
E.2 Available Variables
If you would like to manually build a directory tree based on your require-
ment, you are free to do so. ITP 2.0 contains a wide range of variables that
can be used, which are covered over the next few pages. These variables
can be used in a wide variety of fields, and if necessary the controls that do
allow their use typically have a small button marked % that will allow you
to interactively add them.
• %ipaddress% - Replaced with the IP Address of the device that trans-
mitted this image to the computer.
• %host% - Will be replaced with the host name of the device that
transmitted this image to the computer (uses the host list).
• %user% - The username of the logged in user will replace any occu-
rances of this variable.
• %prefix% - Will be replaced with the prefix setting that is currently
being used.
• %date% - The full written date that the image was uploaded to the
server (eg September 23 2005).
• %daten% - Will be replaced with the full numeric date that the image
was uploaded (eg 23-09-2005).
• %datern% - Replaced with the full numeric date the image was up-
loaded in reverse order (eg 2005-09-23).
• %datetree% - Replaced with the date the image was uploaded in
reverse order and separated into three levels (eg 2005/09/23/)
• %datetreelong% - Will be replaced with a directory tree based on
the date the image was uploaded but with the written month (eg
2005/September/23)
74