Specifications

WITE32 Release Notes Version 3.20
2. The Disk Product Parameters frame in the Spinstand Product Parameters dialog box has a new layout
(see Figure 19). All controls in this frame are the same as they were in the WITE32 version 3.11.
3. The parameters of 3.5 Inch media will be used for the product parameters initialization when the DDT file is
not found or not specified.
4.1.5 V2002 Head Stack Product Parameters
The Product Parameters dialog box displays the same control items for both a V2002 head stack tooling and a
standard HLM-V2002. However, some text boxes, content of which you can edit in case of the HLM-V2002,
are the read-only text boxes in the Product Parameters dialog box of the head stack tooling (see Figure 19).
These read-only text boxes show the parameters, which are programmed at Guzik Technical Enterprises, stored
in the EEPROM on the head stack tooling, and cannot be altered by the user.
The text boxes for the following head stack tolling parameters are the read-only items:
• Loading Radius
• Unloading Radius
• ID Radius
• OD Radius
• Angle on ID Radius
• ID Radius for Angle
• Angle on OD Radius
• OD Radius for Angle
Figure 19: Product Parameters Dialog Box for V2002 Head Stack
44 Guzik Technical Enterprises