Specifications

WITE32 Release Notes Version 3.20
CHAPTER 3
NEW FEATURES INTRODUCED IN
WITE32
3.1 Guzik Servo Revision 3
Starting from the WITE32 version 3.20, the RWA of the 2000 series equipped with the Servo Revision 3
hardware operates only in Servo Revision 3 mode. Refer to the manual Guzik Servo Revision 3 For RWA-2000
Series (P/N 02-107283-03) for the description of the Guzik Servo Revision 3.
WITE32 version 3.20 does not support a combination of Servo-3 RWA and Servo-2 spinstand. The following
error message is displayed if WITE32 software detects such configuration: "Servo-2 spinstand and Servo-3 RWA
are incompatible. Please, contact Guzik technical support".
The previous version of WITE32 software does not support the Servo Revision 3 mode. The test system
equipped with an RWA of the 2000 series with the Servo Revision 3 hardware and WITE32 version 3.11 was
able to work in the Servo Revision 2 mode only.
To verify the servo revision supported by your test system, open the Hardware Features dialog box. To do this,
select Info | Hardware Features… menu item on the main menu of the WITE32 Engineering Dashboard.
3.2 Perpendicular Parametric Test Module
The Perpendicular Parametric Measurements test module is available starting from the WITE32 version 3.20.
This test module requires an additional license. Contact Guzik Sales department for quotation.
See “WITE32 Perpendicular Parametric Measurements Test Descriptions Engineer's Reference”
(P/N 02-107279-02) for the module description.
3.3 Guzik V2002 Spinstand
The following new features are introduced for Guzik V2002 spinstand:
• The Head Recovery procedure for comb loader and head stack tooling (see Section 3.3.1)
• The Head Alignment Revision 2 (see Section 3.3.2)
• The Lock Motors mode (see Section 3.3.3)
• The Disk Chuck Type test box in the V2002 Spinstand Parameters dialog box (see Section 3.3.4)
8 Guzik Technical Enterprises