Installation Guide
7. Cleaning and Maintenance
7.1 Before cleaning the appliance,disconnect it from the socket and let it cool down. The enclosure is easily to
get dirty, wipe it often with soft sponge. For every dirty parts, wipe with a sponge dipped in <50°C water
and mild detergent, then dry the heater enclosure with clean cloth. Be careful not to let the water enter
the appliance inner. Don’t splash water onto the heater,never use solvent like gasoline etc. to clean the
heater,in order to protect the enclosure.
7.2 Clean the cord and plug,dry and pack it in a plastic bag.
7.3 When you store the heater, let it cool down rst, keep it dry. Then cover it with a plastic bag, put in a
packing box and store it in a dry, ventilated place.
8. Trouble shooting:
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the service centre.
Problem Possible cause Treatment
The heater does not
operate,even when it is
plugged in and the switch,
thermostat are switched on.
The plug is loose, bad connection
Pull out the plug, check the
connection of the plug and socket.
Then connect again.
No power in socket outlet Insert the plug in a proper socket
The heating element
glowing
The input voltage is too high or
too low
Use power supply according to
the rating on the label
The air inlet grill is blocked
Keep the heater far way from
articles like curtain, plastic bag,
paper and other things which can
cover the inlet or can be easily
cover on the air inlet
The appliance didn’t heat up,
or only ventilator worked
The switch was not put at heating
setting
Turn the switch to heat setting
The thermostat operated
Turn the thermostat and listen if
there is open/close voice. If there is
no click and the thermostat is not
damaged, the heater will automatic
switch on when the appliance
cooled down
The self-resetting cut-out operated
Turn the heater o and inspect
the blockage of inlet or outlet.
Disconnect the plug and wait at
least 10 minutes for the protection
system to reset before attempting
to restart the heater.
Abnormal noise The appliance is not stands upright Put the heater on a level surface
Model identier(s): GP 08 24
Item Symbol Value Unit Item
Unit
Heat output Type of heat input, for electric storage local space heaters only (select one)
Nominal heat output Pnom 2.4 kW Manual heat charge control with integrated thermostat [no]
Minimum heat output (indicative) Pmin 1.2 kW
Manual heat charge control with room and/or outdoor
temperature feedback
[no]
Maximum continuous heat output Pmax 2.4 kW
Electronic heat charge control with room and/or outdoor
temperature feedback
[no]
Auxiliary electricity consumption Fan assisted heat output [no]
At nominal heat output elmax N/A kW Type of heat output/room temperature control (select one)
At minimum heat output elmin N/A kW Single stage heat output and no room temperature control [no]
In standby mode elSB N/A W Two or more manual stages, no room temperature control [no]
With mechanic thermostat room temperature control [yes]
With electronic room temperature control [no]
Electronic room temperature control plus day timer [no]
Electronic room temperature control plus week timer [no]
Other control options (multiple selections possible)
Room temperature control, with presence detection [no]
Room temperature control, with open window detection [no]
With distance control option [no]
With adaptive start control [no]
With working time limitation [no]
With black bulb sensor [no]
Contact details: See cover page with contact information
Remark:
For electric local space heaters, the measured seasonal space heating energy eciency ηs cannot be worse than the declared value at the nominal heat
output of the unit.
Disposal Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
EN