Manual

IMPORTANT
Please read these instructions
carefully before you start to
assemble this product.
Please carry out the steps in
the order set out in these
instructions.
Keep these instructions in a
safe place for future reference.
Safety advicc
For safety purposes we
strongly recommend the product
to be assembled by at
least two people.
Some parts may have sharp
edges. Please be careful when
handling components.
Always wear gloves, eye
protection, and long sleeves when
assembling or
performing any maintenance
on your product.
Do not attempt to assemble
the product in windy or wet
conditions.
Do not attempt to assemble
the product if you are tired,
have taken drugs,
medications or alcohol, or if
you are prone to dizzy spells.
Dispose of all plastic bags
safely - keep them away from
children's reach.
Keep children away from the
assembly area.
When using a stepladder or
power tools, make sure that
you are following the
manufacturer's safety advice.
Do not climb or stand on the
roof.
Do not hang or lay on the
profiles.
Heavy articles should not be
leaned against the poles.
Keep roof and gutters clear of
snow, dirt & leaves.
Heavy snow load on the roof
can make it unsafe to stand
below or nearby.
If
color was scratched during
assembly it can be fixed.
Cleaning
instruction_
In
order to clean the product,
use a mild detergent solution
and rinse with
cold clean water.
Do not use acetone, abrasive
cleaners, or other special
detergents to clean the
panels.
Clean the product once
assembly is complete.
Tools & Equipment
.---..--
Tool (Supplied)
Before
Assembly
Choose your site carefully
before beginning assembly.
The ground surface must be
perfectly flat and leveled and
have a solid base such
as
concrete, asphalt, deck etc.
Sort the parts and check
against the content parts list.
Parts should be laid out close
at hand. Keep all small parts
(screws etc.) in a bowl so
they do not get lost.
Please consult your local
authorities if any permits are
required prior to
constructing the product.
A
Attention
Please make sure you
install the panels with the
UV protected side
out (marked with
"THIS SIDE OUT") and remove the
sticker as panels are in
place.
Louring
Assembly
When
encountering the information icon,
please refer to the relevant
assembly
step for additional comments
and assistance.
).
During assembly use a
soft surface below the parts
to avoid scratches
and damages.
Steps
Step 8:
Carefully spread
silicone glue along the
cross-section of the profile and at
once
attach the profiles
together. Recommended to
wipe the extra residue
silicone.
Steps 9-15:
It is recommended
to use a carton or other soft
material under the lowered
corner in order to
avoid scratches and peeling of
paint.
Step 13:
Optional - if you
wish to add Palram's Curtains or
Netting Set, please thread
the
plastic clips through
the rail in each profile.
(Palram's Curtains /
Netting Set are not supplied).
Steps 14+16:
Drawing a
Please note that
threading of the screws should
be done from the outside,
and
nuts threaded from
the inside.
Steps 15+17:
Please note that
threading of the screws should
be made from the bottom up.
Step 18:
Please add silicone
on the inner area of part #
8327 as illustrated
Step 25a:
Please drill holes in
the panels to be located
precisely parallel to the holes in
profiles #7744 +
#7743
Step 26:
Please level the
profiles' legs and adapt screws
and plugs to your specific
ground
type.
* Please tighten all
screws when completing
assembly.
Note:
Anchoring this
product to the ground is essential
to its stability and rigidity.
It is required to
complete this stage in order for
your warranty to be valid.