1. Carefully place the table top (#1) facing down onto a protected surface. 2. Prepare 8 bolt assemblies by first inserting the lock washer (#B) onto the bolt (#D) then a flat washer (#A) onto that same bolt (#D), in that order. 3. Align the top of the legs (#2) to the predrilled holes along the table top (#1). Insert 4 prepared bolt assemblies into each leg (#2) and secure using the Allen wrench (#E). 1.
1. Carefully place the backrest w/legs (#1) onto a protected surface. Insert the back side of the seat (#2) into the pre-drilled holes located along the front of the backrest w/legs (#1). 2. Prepare a bolt assembly by first inserting a lock washer (#B) onto the bolt (#C) then a flat washer (#A) onto that same bolt (#C), in that order. Insert into center hole and secure using the Allen wrench (#F).
1. Align the front legs (#3) to the pre-drilled holes located on the front corners of the seat (#2). 2. Prepare 4 bolt assemblies by first inserting a lock washer (#B) onto the bolt (#D) then a flat washer (#A) onto that same bolt (#D), in that order. Insert into the front corner holes and secure using the Allen wrench (#F). Carefully turn the completed chair upright. Make sure the chair is rested on a flat surface and does not feel loose or wobbly.