Assembling & Installation Instructions

ManualsBrandsCanora Grey ManualsLantern Outdoor Wall LightingMamie 3-Light Outdoor Wall Lantern

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture

and all hardware from Junction Box. Carefully unpack your new

fixture and lay out all the parts on a clear area. Take care not to

lose any small parts necessary for installation.

2. Disconnect power at main electrical panel before installation.

3. Attach the mounting plate to the junction box using two junction

box screws as shown. The side of the mounting plate marked

“GND” must face out. The junction box is not included.

4. Guide fixture wires through hole in center of mounting plate.

5. Follow wiring instructions carefully (see fig.2).

6. Attach the back plate of lamp body onto the mounting plate,

aligning the back plate holes with screw hole of the mounting

plate on side, then lock it securely with mounting screws. Put the

candle sleeve over the lamp holder.

Install the light bulbs(No Included) in accordance with the fixture's

specifications. NOTE: DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

With silicone caulking compound, caulk completely around

where back of cover meets with the wall surface to prevent

water from seeping into outlet box.

from the fixture to the black house (hot) Wire. Connect the white

wire from the fixture to the white (neutral) house wire. Make sure

all wire nuts are secured. You may wrap the connections with

electrical tape. If your outlet box has a ground wires (green or

bare copper) connect fixture’s ground wire to it. Otherwise attach

the bare copper fixture wire to the green ground screw on the

mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

Thank you for purchasing our product.

Need assistance with parts or assembly? Please call customer service

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area.