User Manual

How to use the 3M Adhesive Mount:

I. Loosen the (c) locking ring on the suction mount and pull the (e) magnetic

connector out.

ii. Next, loosen the (c) locking ring from the 3M adhesive mount, and plug the

(e) magnetic connector into the 3M adhesive mount.

iii. Clean the installation area on the windshield and peel off the plastic covering.

Adhere it to the windshield.

Loosen

Tigten

3. ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING

Remove the protective plastic film and select a location on the windshield where

won’t distract you. Then, put the suction mount in place.

Release the (b) locking lever from the mount by pulling down on it. Hold the

suction mount in place and press against the window. While holding it in place,

pull the (b) release lever back to lock the mount.