User Manual

9
IP network cameras.
2.3.24 Network bandwidth testing
The network bandwidth test needs two IP testers to test bandwidth: one as a transmitter, the other as a
receiver.
2.3.25 IP address scan
The IP address scan can quickly search for connected IP cameras or another network device IP address.
2.3.26 PING Test
PING is the most conventional network debugging tool; it is used for testing if the connected IP camera
or other network equipment is working normally and the IP address is correct
2.3.27 Port Finder
The tester will send signals to make the connected PoE port flicker at a set frequency. This will enable
the installer to easily and quickly find the connected port for an Ethernet cable.
2.3.28 PoE Test
Test the PoE voltage from a PoE switch. The unit will clearly display the voltage for each wire in an
Ethernet cable.
2.3.29 Digital Multi-meter（* Optional ）
The tester built in highly stable and reliable 33/4 digit (6600) digital multi-meter. It is used for the DC
and AC voltage measurement, AC and DC current measurement, Resistance measurement, Continuity
test, Diode measurements, Capacitance measurement, Auto/Manual measuring range switching, relative
value measurement and locking. It is easy operation and professionally accurate.
2.3.30 Visual fault locator（* Optional ）
Visual Fault Locator with 650nm wavelength can emit red laser sources to test multi-mode and single
mode fiber’s bending and breakage, and Continuous light-emitting and 1HZ, 2Hz modulating light
output. It is indispensable tool in fiber project constructing, fiber net-work maintaining, optical
component manufacture and research.