User Manual

49
3.3.6 IP address scan
Connect the cable to the LAN port, click icon to enter, set initial IP and destination IP address,to
the tester’s IP address network segment can be the same or different to the scanned network device’s
network segment, then click the key “Start” to scan, quickly to search the IP address, also can input the
IP address in the Port Number Scan to scan to port number ,check the tested device’s supporting port
number and how many ports can support the device’s network communication..
3.3.7 PING Test
PING is the most conventional network debugging tool; it is used for testing if the connected IP camera
or other network
Equipment’s Ethernet port is working normally and the IP address is correct.
Connect a network cable to the LAN port and click the icon to open the PING tool. You can set
your LOCAL (native) IP address, Remote IP address (e.g. IP camera), Packet count, Packet Size, Packet
time and Timeout. Press “Start” to start pinging. If the IP camera or network device is not configured
properly or not plugged in, it will say “Destination host unreachable,” or have 100% packet loss. If the
tester connects to the device, the send and receive packets will have a 0% packet loss.