- 3Com Baseline Switch 2250 Plus User Guide

12 CHAPTER 1: INTRODUCING THE BASELINE SWITCH
(5) Power LED
The Power LED shows the power status of the Switch.
Tab le 7 Power LED
(6) Self-Adhesive Pads
The unit is supplied with four self-adhesive rubber
pads.
Do not apply the pads if you intend to rack-mount
the unit.
If the unit is to be part of a free-standing stack, apply
the pads to each marked corner area on the
underside of the unit. Place the unit on top of the
lower unit, ensuring that the pads locate with the
recesses of the lower unit.
Rear Panel
(7) Power Supply
The Switch automatically adjusts to the supply volt-
age. Only use the power cord that is supplied with
the unit.
(8) Recovery Button
Use the Recovery button on the rear panel to reset
the Switch to its factory defaults. For more informa-
tion, refer to “
Resetting to Factory Defaults” on
page 59
.
Package Contents
The 3Com Baseline Switch 2250 Plus package
includes the following items:
■ One 3Com Baseline Switch 2250 Plus unit
■ One power cord
■ Four standard height, self-adhesive rubber pads
■ One mounting kit
■ One CD-ROM, which contains this User Guide and
the 3Com Discovery application
■ One warranty flyer
Before installing and using the Switch, verify that your
Switch package has all these items. If any of the
above items are damaged or missing, contact your
3Com network supplier immediately.
Status Meaning
Green The unit is powered on and ready for use
Flashing
Green
Power-on self-test is in progress
Yellow Power-on self-test or loopback test failed. If this
occurs, reset the Switch to factory defaults. Refer
to
“Resetting to Factory Defaults”
Off The unit is not receiving power:
■ Verify that the power cord is connected cor-
rectly
■ If the unit still does not operate, contact your
3Com network supplier