Operation Manual

ENG

Connection

Please ensure that all electrical components are switched off before connecting. There are various ways of connecting

the Canton Digital Movie System depending on the type and conﬁguration of your television or audio sources.

TV/DVD Input (analogue)

Modern televisions have a “Pre-Out” stereo output. Connect this to the input of the DM System

marked “TV”. Alternatively the headphone output of your TV can be connected with the TV input

of the DM 8.2. To transmit the DVD audio signal connect the audio outputs of your DVD player to

the inputs of the DM System marked “DVD”. To transmit the visual signal your DVD player must

also be connected to your television.

AUX (digital)

The digital input marked „AUX“ on the DM system can be used to connect the source of your

choice with an optical digital output (e.g. TV, satellite receiver, BD player etc.) In this case you

should use the optical digital output of your source device.

WARNING: Make sure that the connected device is set to the correct setting. The DM 8.2

system can only reproduce sound if you have selected „PCM-Stereo“ or „PCM-Downmix“

in the sound menu of your source device. „DTS

“ or ”Dolby Digital

“ coded output formats

(Bitstream or RAW) cannot be reproduced. If you have any questions about the settings please

refer to the instructions provided with your source device.

Output

To connect an external subwoofer use the output of the DM System marked “SUB OUT”.

Note

Make sure that you connect the left and right channels correctly and only use shielded cinch

cables to avoid the transmission of any interference. An optical digital cable (Toslink) should be

used to connect a device with digital output.

SUB

DIGITAL MOVIE

TV DVD AUX

DVD AUX