Installation Instructions

46
English
Option 1
Requirements:
- The device should be connected to a router, to ensure that a network connection can be recovered in
case of any fault during the update process
- Always use the latest version of the firmware. Follow the steps 1–5 of the next chapter “update over the
network” to find the firmware version installed on your musicbox Air 3. Download the most recent version
from www.canton.de or contact the Canton customer service department
- The USB storage stick must be formatted with FAT 32
Procedure:
1. Save the update file directly into the main folder of your USB storage stick
2. Switch on the musicbox Air 3 and wait until the LED ring has stopped flashing rapidly (2x per second)
3. Now plug the USB storage stick into the USB port of the musicbox Air 3 and wait at least 10 seconds
4. Press the RESET and WP SETUP buttons at the same time until the LED ring is illuminated in all colours.
After around five seconds, the LED ring begins to flash in all colours
5. Please wait until the update has been finished. This process can take up to two minutes
6. After the update, the musicbox Air 3 makes a “clicking sound” and reboots automatically
7. Before taking any other steps, wait until the LED ring is no longer flashing rapidly green (2x per second)
but is illuminated in green (in case a network connection existed previously) or is slowly (1x per second)
blinking green
8. The USB storage stick can be removed now
Warning:
Do never interrupt the mains connection while the update is in progress and do not turn off the
musicbox Air 3. Do not remove the USB storage stick during the update process.
Update over USB
Firmware update
There are two ways to do a firmware update on your musicbox Air 3