HARBOUR COLLECTION ARMCHAIR PRODUCT N0. 088 -2018-0 ASSEMBLY INSTRUCTIONS Toll-free: 1-888-670-6684 IMPORTANT: Please read this manual carefully before beginning assembly of this product. Keep this manual for future reference.
Table of Contents 3 Important Safety Instructions 3 Part List 4 Assembly 5 Cleaning and Maintenance 11 Technical Specifications 11 Warranty 12 TABLE OF CONTENTS 3 PRODUCT NO. 088-2018-0 WARNING! To reduce the risk of serious injury, read the following safety instructions before assembling and using the product. CAUTION! Always keep children under close supervision while they are playing near this product. Never leave children unattended. Keep pets away while setting up the product.
5 PRODUCT NO. 088-2018-0 1 C Left Arm Frame - 1 Washer - 20 + + 2 Spare 2 D Right Arm Frame - 1 Screw Cap - 10 + + 1 Spare 3 E Back Panel - 1 Screw Nut - 10 + + 1 Spare 4 F Seat Panel - 1 Nut Cover - 10 + + 1 Spare 5 G Back Cushion - 1 Hex Key - 1 6 H Seat Cushion - 1 Wrench - 1 CAUTION! • Check all screws and nuts periodically for tightness. If required, tighten them. • Keep children away during assembly. This product contains small parts which can be swallowed by children.
7 PRODUCT NO. 088-2018-0 Step 1 Requires B, G Step 3 Requires 1, 2, 3 Insert the shank of the screw (B) into the corresponding hole located on the left side of the back panel (3). Tighten the screw using the hex key (G). Repeat the same procedure on the right side of the back panel. Align holes located on the lower portion of the back panel (3) with the corresponding holes of the right arm frame (2). Repeat the same procedure for the left arm frame (1).
9 PRODUCT NO. 088-2018-0 Step 7 Requires 3, 4 ASSEMBLY Step 5 Requires 1, 2, 4 Tilt the assembled panel. Align holes located on the right arm frame (2) with the corresponding holes on the front of the seat panel (4). Repeat the same procedure for the left arm frame (1). 1 4 4 3 3 4 4 2 2 Step 8 Requires A, C, E, G, H Step 6 Requires A, C, E, G, H Insert the screw (A) with one washer (C) into the aligned hole. Tighten the screw using another washer and a screw nut (E).
11 PRODUCT NO. 088-2018-0 Step 9 Requires D, F ASSEMBLY After assembling all the chair parts, make sure all screws are fully tightened. Cover all screws and screw nuts using the screw caps (D) and screw nut covers (F). D F • Check all screws periodically for tightness. If required, tighten them. • If required to disassemble the product, follow the assembly steps in the reverse order. • Fabric colour may fade after prolonged exposure to light. Keep the cushions indoors when not in use.
12 PRODUCT NO. 088-2018-0 WARRANTY This CANVAS™ product carries a one (1) year warranty against defects in workmanship and materials. Trileaf Distribution agrees to replace the defective product free of charge within the stated warranty period, when returned by the original purchaser with proof of purchase. This product is not guaranteed against wear or breakage due to misuse and/or abuse.
