Installation Sheet

ManualsBrandsCapital Lighting ManualsBathroom LightingCapital Lighting 3 Light 25.75" Wide Bathroom Fixture from the Tahoe Collection

Page 1 of 1

Components

01. Universal Bar

02. Outet Box Mounting Screws

03. Mounting Screws

04. Allan Wrench

05. Fixture

06. Socket

07. Glass Shade

08. Socket Ring

1. Attach Universal Bar with fixture mounting tabs vertically (01) to Outlet Box with Outlet Box Mounting Screws (02).

2. Connect fixture ground wire to outlet box ground wire with wire connector supplied; connect white fixture wire to the white power

supply wire with wire connector supplied; connect black fixture wire to the black power supply wire with wire connector supplied.

3. Push Fixture (05) to wall, make sure mounting holes in Fixture canopy and Universal Bar (01) are in line, verify all wires are securely

inside fixture back plate, and then secure fixture to wall with Mounting Screws (03) and Allan Wrench (04).

4. Put Glass Shade (07) over Socket (06) onto glass holder of Fixture (05), then secure it with Socket Ring (08).

Assembly Instructions for the 8343 fixture

Approved by: Brasselle, Glenn Last Updated: 05/23/2015

Important Safety information (Please read before proceeding)

ASSEMBLY AND INSTALLATION INSTRUCTIONS for the 8343 Fixture

1. Remove the fixture, parts and all mounting hardware bags (orange) from the carton and verify that all parts are present according to the illustration sheet. All parts must

be used as indicated. Do not replace any parts, leave any parts out, or use any parts which are worn out or broken. Failure to follow the instructions could cause a

hazardous situation, voids the warranty and violates the U.L. listing of the fixture.

2. To prevent the electric shock, turn off the main power at the circuit breaker before installing the fixture. NEVER attempt to install, clean or replace bulbs without

shutting off the electricity to the fixture.

3. Never use light bulbs with wattage ratings that exceed the fixtures maximum rating. Always make sure the electric current is turned off before changing the

bulbs.

4. If you experience difficulties installing the lighting fixture or it fails to work as expected, please contact a local qualified licensed electrical contractor.

5. Please contact your local Capital Lighting Fixture reseller with any assembly or installation questions. Your local reseller can also provide you with replacement parts for

your new fixture.