User's Manual

User can exit the premises within the preset delay duration. After this preset delay duration,
the dialer will be in arm mode.
When any sensor monitored by the dialer is triggered, the dialer will beep for preset duration.
This duration allow user to go to the dialer and deactivate it before it begins to dial. If you
successfully aborted the call, the display will go back to standby mode. If the dialer has not
been deactivated within the preset duration, the dialer will dial the emergency phone numbers.
Disarm the dialer
[MPIN] + [ARM]
Arm LED will goes off.
When the dialer is beep for entry, user can disarm the dialer. The dialer will stop beeping and
go back to standby mode.
But if the dialer is started to dial the emergency phone numbers in arm mode, user can enter
correct MPIN in order to terminate the call. User cannot hold the panic button to terminate the
call.
However, when the dialer is calling the emergency phone numbers in disarm mode, user can
hold the panic button to terminate the call. User cannot enter MPIN to terminate the call.
Receiving the emergency call
When the phone rings at the calling location, the person who answers the phone will hear a
message related to the emergency events. User can hear the main message first. If the dialer
received enough information from the sensor, user can also hear the second message. The
message may be repeated several times depending on how it was programmed.
User can enter “#” to terminate this call, this will also stop calling you.
User can also enter 4-digit password to terminate the call, this will also stop calling remain
emergency call. The dialer will enter standby mode.
Warranty
If, within one year from date of purchase, this product should become defective (except
battery), due to faulty workmanship or materials, it will be repaired or replaced, without charge.
Proof of purchase is required.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.