User's Manual

GARAGE DOOR REMOTE CONTROL

USER’S INSTRUCTIONS

(MODEL : CSL-2)

PROGRAMMING YOUR NEW TRANSMITTER

1. Open the case with a corn.

2. For code setting:

With the receiver unit plugged in the AC outlet, press and hold the ‘learn’ button

on the receiver and its LED light will flash. Then press the button on the

transmitter until the receiver light stops flashing indicating it has learned the code.

3. Test the receiver unit with the transmitter.

LIGHT

Press the case to emit the light.

BATTERY

One 3 volt Lithium type (CR2032) battery included.

WARNING

If this transmitter triggers other garage doors in your neighborhood, change all your

transmitters and receiver to a new code setting.

DO NOT let children use the

garage door transmitter

without adult supervision.

Children can injure

themselves or others by the

garage door.

WARRANTY

If, within one year from date of purchase, this product should become defective (except

battery), due to faulty workmanship or materials, it will be repaired or replaced, without

charge. Proof of purchase is required.

FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesired

operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

PAGE 1
GARAGE DOOR REMOTE CONTROL USER’S INSTRUCTIONS (MODEL : CSL-2) PROGRAMMING YOUR NEW TRANSMITTER 1. Open the case with a corn. 2. For code setting: With the receiver unit plugged in the AC outlet, press and hold the ‘learn’ button on the receiver and its LED light will flash. Then press the button on the transmitter until the receiver light stops flashing indicating it has learned the code. 3. Test the receiver unit with the transmitter. LIGHT Press the case to emit the light.
PAGE 2
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna.