Technical information

7
step 3b: backguard installation
Fig. 2Ab
1. Remove the range back panel by removing
the 6 screws -- 3 screws on each side
(see Pics. A and B).
2. Remove, then discard the 4 screws
(2 at each side at the top of range side trim).
3. Set IT, LB or HS on top of the range (Pic. C)
and secure it with the two (2) screws at each
end from the bottom of the range side-trim
(Pic. D).
4. Replace the range back panel by sliding it
under the bottom lip of high shelf (Pic E).
5. Secure the IT, LB, or HS to the range back
panel with five (5) screws across the back
on 24, 30, and 36 inch ranges; and seven (7)
screws for 48" ranges (Pic. F).
6. Replace the final six (6) screws (3 on each
side of range back).
CAUTION!
DO NOT USE THE LOW BACK
OR HIGH SHELF TO MOVE RANGE.
Pic. A
Pic. F
Pic. E
Pic. D
Pic. C
Pic. B