C125F Built-under Freezer INSTRUCTIONS FOR USE Caple Quality Products Consumer Help Line 0870 2411142 1 C125F Built-under Freezer instructions.
This section details the main safety warnings. Read it carefully before installing and using the equipment. • • • • • • • • • • • • • • • • • Always keep the instruction manual and, if you sell the equipment, hand it over to the new owner. This equipment must not be installed outdoors, not even under the cover of roofing; it is extremely dangerous to expose it to rain, storms and bad weather in general.
ENVIRONMENTAL INFORMATION This equipment was designed and built with the maximum respect for the environment. To guarantee the same scrupulosity when it's disposed of (given the presence of pollutant or inflammable materials, e.g. lubricant in the compressor), never abandon the equipment outside. Contact the local authority responsible for collection and disposal. Don't throw the packaging material from your equipment in the rubbish but sort the various materials (e.g.
INSTALLATION IN KITCHEN FURNITURE In the case of modular kitchen assemblies with the dimensions indicated in Figure 12, the unit may be installed under the worktop. Pre-installation warnings A front panel (door) is sufficient for installation. If the equipment is mounted at either end of a kitchen block, it is also necessary to provide covering for the sidewall. We recommend placing the power outlet in an easily accessible position, preferably outside the area hidden by the equipment.
Mounting the Furniture Door • There are no holes on the panel, so they must be drilled, as shown in Figure 5. • Having fixed the panel to the hinges as indicated in Figs. 7-A and 8-A, proceed with registration of the panel using the regulation screws (Figs. 7-B and 8-B). • Having completed registration, tighten the • Bottom support screws as shown in Figure 9. 5 C125F Built-under Freezer instructions.
WARNING It is important to ensure access to the equipment's power outlet in the wall, so that the plug can be removed if necessary. If this isn't possible, connect the equipment to the mains via a double pole switch with a contact opening distance of at least 3 mm in an accessible position. ELECTRICAL CONNECTION Connection of the equipment to a power outlet with an earth contact is required by law. For this reason the equipment is provided with a plug with an earth wire to fit in an outlet of the same type.
GETTING TO KNOW YOUR FREEZER The freezer you've chosen allows you keep frozen food and freeze fresh food (see section on freezing). Temperature regulation control panel The temperature can be regulated by means of the thermostat. Position 0 means equipment operation suspended (off) Position 1 means equipment operation at minimum Position 4 means equipment operation at maximum 1. Thermostat: temperature regulation 2. Green LED: freezer powered by mains supply 3.
• • • To preserve flavors, consistency and freshness we suggest wrapping the food in aluminium or cling foil and placing it in the appropriate containers with a lid. Do not put glass containers with warm liquid in the freezer compartment. Foods, which easily absorb smells and flavors, should be kept hermetically sealed. ICE CUBE PRODUCTION Fill the special pans three quarters with water and place them in the compartment.
MAINTENANCE AND CLEANING Unplug the appliance before commencing any kind of maintenance. To clean the inside of the appliance and accessories we suggest you use a water and vinegar solution; never use abrasives, detergents or soap. The shelves are attached to the sides of the door frame. Clean periodically the water drain hole, located on the rear wall with a ramrod or a blunt stick. Clean the door gasket with water and dry carefully.
• The compressor evaporation tub is full of residues and must be cleaned. If normal operation cannot be achieved after completing the above checks, contact your nearest service center. Please see the attached slip to find out where it is. The manufacturer shall not be held responsible for any damages that may, directly or indirectly, be caused by persons, pets or things, resulting from the failure to comply with all the guidelines given in the instruction handbook.
CAPLE "Built-in" Service Should you require service at any time, please contact the Caple Help line on 0870 2411142. Caple have a nationwide service network of engineers who will respond quickly to your call. Always replace spare parts with genuine Caple spares. These are available from authorized Caple Service Centers or by mail order from our National Service Stores, simply telephone 0870 2411142. When ordering parts always quote the model number and serial number of your appliance.
