User manual

3
C210L C210_46 user manual.doc
ENVIRONMENTAL INFORMATION
This equipment was designed and built with the maximum respect for the environment.
To guarantee the same scrupulosity when it's disposed of (given the presence of pollutant or
inflammable materials, e.g. lubricant in the compressor), never abandon the equipment
outside. Contact the local authority responsible for collection and disposal.
Don't throw the packaging material from your equipment in the rubbish but sort the various
materials (e.g. polystyrene, cardboard, plastic bags) as required by local waste disposal authorities
in pursuance of current legislation.
This equipment does not contain CFCs (the cooling circuit contains R134a) or HFC’s (the cooling
circuit contains R600a - ISOBUTANE).
To check what gas is used, see the technical data plate on the equipment.
For equipment with ISOBUTANE (R600a)
Isobutene is a natural gas that doesn't affect the environment, but it is inflammable.
It is therefore indispensable to check that the cooling circuit tubing is not damaged before
connecting the equipment to the mains.
• For every 8 g of cooling fluid, the installation location must have a minimum volume of 1 cubic
meter. The amount of cooling fluid in the appliance is indicated on the technical data plate
inside the freezer.
• Leakage of cooling fluid: avoid naked flames or other sources of ignition at the seat of the
leakage.
INSTALLATION
The appliance should be installed by two persons, so as not to injure people or damage things.
If damage occurs while the appliance is being dispatched, advise the supplier immediately before
connecting it.
Read the climatic class of the appliance on the specification plate located on the inner left side,
“SN” (works at ambient temperatures ranging ) from +10°C to +32°C
“N” (works at ambient temperatures ranging) from +16°C to +32°C
“ST” (works at ambient temperatures ranging) from +18°C to +38°C
“T” (works at ambient temperatures ranging) from +18°C to +43°C.
Install the appliance in a dry and well aired place, away from heat sources, such as radiators,
stoves, cookers, sun rays etc.
The appliance must be installed on stable and flat surface, by adjusting the feet, if any.
A gap of at least 20mm and 100mm must be left between the rear of the appliance and the wall
towards any wall-mounted, units above the appliance.
Do not place on the refrigerator/freezer any heat-emitting appliances such as: microwave ovens,
toasters etc.
Should the refrigerator be enclosed, in the kitchen cabinet make sure airing gap “A” is at least 200
cm
3
, and the venting duct on the rear of the cabinet is at least 50mm deep, follow the instructions
in the figures about installation.
Make sure that no appliances or electric components are installed near the vents