User manual
6
C210L C210_46 user manual.doc
Never use sharp objects or metal tools, humidifiers, heaters, hair-dryers, antifreeze spray for this
operation. They might damage the refrigerating circuit irreparably and pose a hazard in appliances
operating with R600a.
Take the following steps to defrost:
• Unplug the appliance or switch off the main power switch
• Take foods out of the deep-freeze compartment
• Turn the thermostat to setting 0
• Wipe up the water produced by defrosting with a sponge or cloth
• Dry the walls and/or wire cooling shelves Plug in the appliance, turn the thermostat as
required (Refer to the paragraph entitled "Getting to know the appliance").
MAINTENANCE AND CLEANING
Unplug the appliance before commencing any kind of maintenance.
To clean the inside of the appliance and accessories we suggest you use a water and vinegar
solution; never use abrasives, detergents or soap.
The shelves are attached to the sides of the door frame.
Clean periodically the water drain hole, located on the rear wall with a ramrod or a blunt stick.
Clean the door gasket with water and dry carefully.
If the appliance must be idle in the long term, unplug and empty it, clean the inside and leave the
door open (to prevent bad stenches).
WARNING
Under no circumstances should a steam cleaner ever be used for defrosting or cleaning.
Steam may damage live parts of the equipment and cause a short circuit or electric
shocks. Steam may damage plastic parts.
ENCLOSING CABINET INSTRUCTIONS
Fitting the appliance into the enclosing cabinet see page 8.
• Check that the dimensions of the enclosing cabinet and appliance are compatible.
• If necessary, mount plastic beam B on the upper frame C made of sheet steel.
• Position the appliance by aligning the upper frame C (or the plastic beam B) with the corner of
the enclosing cabinet.
• Shorten strip D to height of the notch and mount it with its adhesive side glued to the wall of
the appliance.
• Push the appliance against the cabinet wall to press in strip D and tighten the top and bottom
fastening screws.
• Mount the brackets for runner E on the outside of the appliance door (using the existing holes)
and with the doors fully open, fit the door runner F on the cabinet door.
• Adjust the coupling between the appliance door and cabinet door and cover the runner screws
with special adhesive caps.
REVERSIBLE DOOR
• Remove the caps of pin R from the top and bottom left hinge
• Remove the caps of the top and bottom door heads and replace them with the sleeves supplied.
• Close the appliance door, loosen side screws S used to lock pins T. Then slide the lock pins into
their hinges. Then remember to fasten them.
• Move the plastic adjusting washers, making sure you do not reverse the numbers between the
top and bottom hinges.
• Loosen the side screws used to support the left hinge pins. Then slide the hinge pins into the
previously fitted door head sleeves and remember to insert the adjusting washers and fit the
pins.
NB: The material supplied is contained in the bag placed in the vegetable drawers.