User manual

C210L C210_46 user manual.doc

REVERSIBLE FREEZER COMPARTMENT DOOR (IF SUPPLIED)

• Detach door stopper Y, hinge bracket X and remove the door.

• Remove the 4 hole caps (2 on the right and 2 on the left)

• Fit door stopper Y on the right side of the appliance.

• Turn over and insert the door with its handle on the right.

• Turn over and mount hinge bracket X on the left.

• Seal the remaining holes using the 4 caps that you removed.

TECHNICAL SUPPORT

Irregular operation is not always caused by a defect in the appliance, but rather by bad installation

or misuse.

To avoid unnecessary maintenance jobs and expenses incurred by calling technical support, we

suggest you follow the guidelines below:

The internal temperature is not cold enough.

Check:

• The door closes perfectly;

• The thermostat is correctly positioned

• The refrigerator is not near any heat sources

• The refrigerator is not leaning against the walls and air circulates freely

• There is no excess hoarfrost in the deep-freeze compartment.

The internal temperature is too cold

Check:

• The thermostat is turned to the correcting setting

The appliance is too noisy

Check:

The appliance is properly leveled

The rear coil does not touch the back wall

The appliance does not work at all

Check:

• The thermostat is not set to 0

• Power supply is not disconnected

• The plug has a firm contact in the wall socket

• The power cable is not broken (see “Caution” paragraph)

Some water seeps out of the refrigerator

Check:

• The drainage circuit

• The compressor evaporation tub is full of residues and must be cleaned. If normal operation

cannot be achieved after completing the above checks, contact your nearest service center.

Please see the attached slip to find out where it is.

The manufacturer shall not be held responsible for any damages that may, directly or

indirectly, be caused by persons, pets or things, resulting from the failure to comply

with all the guidelines given in the instruction handbook. These especially concern

precautions to be taken during installation, operation and maintenance. The

manufacturer also reserves the right to make any changes that may be deemed

appropriate for technical refinement or commercial development at any time and

without having to give prior notice.