Installation manual

Revision 1.9 - 10 -

Installation Dimensions

- Installation Dimension sheets are supplied with each individual ILFP, as there are too many different setup combinations for a

generic installation drawing. When ordering a liftgate, PALFINGER Liftgates supplies a drawing based upon the Chassis dimension

sheet (

Figure 1 and Figure 2) supplied by installing company.

IMPORTANT:

Prior to beginning the installation review installation drawing supplied with your lift gate. It will be in the

format of the example below (Fig. 3) with mounting dimensions specific to the truck/trailer.

Verify that the subject chassis matches all dimensions shown on the installation drawing prior to installation

of the gate. If lift gate and/or chassis do not match the dimensions on the drawing notify PALFINGER

Liftgates before attempting to install the gate.

Do not begin installation if truck/trailer does not match PALFINGER Liftgates supplied drawing!

Figure 3 Installation Drawing - supplied by PALFINGER Liftgates’ engineering department