INSTALLATION AND OPERATING INSTRUCTION BOOKLET F Series Chimney Extractors IMPORTANT: You must read this instruction Book before installing or using this appliance and retain it for future use.
Thank you for buying your new CAPLE Chimney Extractor. To ensure that you get the best results from your new Chimney Extractor, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains installation advice, usage instructions and a cleaning guide, as well as other important facts about your CAPLE Chimney Extractor. If treated with care, your CAPLE Chimney Extractor should give you years of trouble-free use.
Hood Description - Fig. 1 1. Control panel 2. Metal grease filter 3. Worktop illumination Use: Two systems are available Exhaust mode (Fig: S) Vapors are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside.
INSTALLATION When installed, the distance between hood and gas burners or electric plates must be not less than 65 cm providing the total hob output does not exceed 11kw. For each kw in excess of 11kw the distance between extractor and gas hob must be increased by 10cm. ELECTRIC CONNECTION Before completing any connection make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. It is advisable to call a qualified technician to make the electrical connection.
MAINTENANCE Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Metal grease filter (2 or 3 pieces) The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease filters must be washed at least once a month.
Replacing the lamp 1. Disconnect the hood from the electricity. 2. Remove the grease filters (Fig. 2). 3. Illumination: always replace burnt-out lamps with 40-Watt max. (E14) (Fig. 5) -20 Watt max. (Fig. 6) and 11-Watt max. (Fig. 7). 4. Refit the metal grease filters. 5. Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly.
CAPLE "Built-in" Service Should you require service at any time, please contact the Caple Help line on 0870 2411142. Caple have a nationwide service network of engineers who will respond quickly to your call. Always replace spare parts with genuine Caple spares. These are available from authorized Caple Service Centres or by mail order from our National Service Stores, simply telephone 0870 2411142. When ordering parts always quote the model number and serial number of your appliance.