User`s manual

BDM-610000082 Rev A Chapter 1: Introduction 7
– Two Strobes can be configured as readable inputs
• Four USB 2.0 (Universal Serial Bus) Ports
– Supports 480 Mb/s (high-speed), 12Mb/s (full-speed), and 1.5Mbs (low speed) peripherals
– Automatic resettable over-current protection (500 mA @ 5 Vdc per port)
– USB Boot capability
• Serial ATA (SATA)
– SATA revision 2.0 with transfer rates up to 3.0 Gbit/sec
– Compatability mode supports legacy operating systems.
• Utility Port 2.0 Connector
– 1x USB 2.0 (Univseral Serial Bus) Port
–Speaker port (0.1W output)
– Hardware Reset input
– Soft Power Button input
– Battery input for Real Time Clock
• Power I/O
RTD Enhanced BIOS
• User-configurable using built-in Setup program
• Flash-based CMOS Setup - No battery required to store CMOS settings
• Supports boot from SATA, USB, or Ethernet (PXE)
• UEFI (Unified Extensible Firmware Interface) Shell
• Special RTD Reliability Enhancements