Instruction manual
5
Replacement of the electrical feeder cable
To connect the feeder cable to the cooker it is necessary to:
– Remove the screw that hold shield “A” behind the cooker (fig. 1.2).
– Insert the feeder cable of the suitable section (as described in the next chapter) into
the cable clamp “D”.
– Connect the phase and earth cables to the terminal block “B” according to the diagram
in figure 1.3.
– Pull the feeder cable and block it with cable clamp “D”.
– Re-mount shield “A”.
Fig. 1.2
D
B
A
230 V
PEN
L
1
(L2)
Fig. 1.3
FEEDER CABLE SECTION
type H05RR-F
230 V 3 x 0,75 mm
2
PE
Warning!
Before effecting any intervention on the electrical parts the appliance must be
disconnected from the network.