Instruction manual

for the 3rd speed. In order to activate the intensive speed,
press the button for 5 seconds regardless of the status of the
hood. For each speed only the led indicating the set speed
will turn on. The intensive speed is indicated by the ashing
of the led indicating speed 3. The duration of the intensive
speed is 10 minutes; after this time the hood goes back to
the last set speed.
In order to remove the intensive speed press the power button
and the hood will switch o, or press the Fan speed button
and the speed goes back to the previously set one. Speed of
the hood with cyclic trend.
Light button (C)= There are three light levels: High, medium,
low.
From the o position press once for the high level, twice for
the medium level, three times for the low level and four times
to turn the lights o.
The level of the lights has a cyclic trend: High, medium,
low, o.
ATTENTION! This function is only available with halogen
lamps and NOT with LED lamps.
Timer button (D) = With any type of speed (excluding the
intensive speed), by pressing the button, the timer function
is activated for 15 minutes. After this time has elapsed the
hood will turn o (motor and any light on).
If the product purchased is equipped with optional features
such as the courtesy lights or side spotlights, keep the Timer
button pressed for 4 seconds to turn them on. Complete the
same operation to turn them o.
Lights indicator (E) = The lights indicator will switch on when
the lights are on at any level.
Filters indicator (F) = After 30 minutes of operation, the led
of the lters indicator will switch on, not ashing indicating
that the anti-grease lters have to be washed. To reset the
function (with the hood o), press the Fan speed button for
5 seconds. After this operation, the led of the lters indicator
turns o and the setting of the 30 hours starts again from
the beginning.
After 120 hours the led will ash continuously. This means
that the carbon lters have to be replaced (if present). To reset
the function (with hood o) press the Fan speed button for 5
seconds. After this operation, the led of the indicator turns o
and the setting starts again from the beginning
Clean air indicator (G).
With the hood o, press the Power button (A) for 5 seconds to
activate the clean air function. This will switch on the motor
at speed 1 for 10 minutes every hour. The light indicator will
switch on without ashing and the led of the 1st speed will
switch on. In the remaining 50 minutes the light indicator will
ash. The function can be deactivated by pressing any button
except for the light button.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 11 -