Service manual

HP 1651SA/16A - Service
3. Starting from the top, begin pulling filler panel(s) and card(s) out half way. See figure 6-24.
Note
All multi-card modules will be cabled or screwed together. Care should be taken
to pull these cards out together. Refer to the appropriate service manual for any
specific precautions.
TOP CARD
~1
NEXT LOWEST
< 12
18S30/£XI3
Figure 6-24. Endplate Overhang
4. Pull timing module to be serviced completely out.
5. Lay module card(s) on antistatic mat with probe assembJies(s) flat and pointing out to rear of card.
See figure 6-25.
Figure 6-25. Cable Position
6-36