OVENS Installation - Use - Maintenance GB
DEAR CUSTOMER, We thank you and congratulate you on your choice. This new carefully designed product, manufactured with the highest quality materials, has been carefully tested to satisfy all your cooking demands. We would therefore request you to read and follow these easy instructions which will allow you to obtain excellent results right from the start. THE MANUFACTURER IMPORTANT The oven’s data plate is accessible even with the oven fully installed. The plate is visible simply by opening the door.
CONTENTS First use pag.
THE FIRST TIME YOU USE THE OVEN Clean the oven thoroughly with soapy water and rinse well. To remove the lateral frames from smooth-walled ovens, proceed as shown in the figure. Operate the oven for about 30 minutes at maximum temperature to burn off all traces of grease which might otherwise create unpleasant smells when cooking. Important: As a safety precaution, before cleaning the oven, always disconnect the plug from the power socket or the power cable from the oven.
RESPECT FOR THE ENVIRONMENT The documentation provided with this oven has been printed on chlorine free bleached paper or recycled paper to show respect for the environment. The packaging has also been designed to avoid environmental impact. Packaging material is ecological and can be re-used or recycled. By recycling the packaging, you will help save raw materials as well as reducing the bulk of domestic and industrial waste.
CONTROL PANEL FUNCTIONS FUNCTION SYMBOLS ON THE SELECTOR Oven light (stays on while oven is in use). Bottom heating element. Thermostat setting from 50°C to MAX. Top and bottom heating elements. Thermostat setting from 50°C to MAX. Top and bottom heating elements with fan. Thermostat setting from 50°C to MAX. Circular heating element with fan. Thermostat setting from 50°C to MAX. Fan for defrosting. Thermostat setting at 0°C. Bottom heating element with fan. Thermostat setting from 50°C to MAX.
INSTRUCTIONS FOR USE CONVENTIONAL COOKING Conventional cooking uses top and bottom heat to cook a single dish. Place the food in the oven only once cooking temperature has been reached, i.e. when the heating indicator goes out. If you want to increase top or bottom temperature towards the end of the cooking cycle, set the temperature control to the right position.It is advisable to open the oven door as little as possible during cooking.
GRILL COOKING Use the grill to grill or brown foods. KEEP THE DOOR CLOSED. Some ovens may be equipped with an electric motor, spit and skewers for turning on the spit. Place the shelf with the food to be cooked in the 1st or 2nd position from the top. Pre-heat the oven for 5 minutes. Turn the thermostat to a temperature between 50° and 200°. COOLING FAN The fan is positioned on the upper part of the oven and create a circle of cooling air on the inside of the furniture and through the door of the oven.
THERMOSTAT Use the thermostat to set the cooking temperature you need. The thermostat can be adjusted from 50° to 250° C. 0-11 HEAT REGULATOR 0-6 SELECTOR Use these to adjust the heat in the cast iron or glass-ceramic plates. Increase the setting from 0 to 6 or from 0 to 11 to raise the temperature. ALARM TIMER You can set this timer to sound a buzzer after 0 to 60 minutes of cooking. First turn the knob fully clockwise, then turn it back to the desired alarm time.
6 KEY ELECTRONIC TIMER Setting the clock Press the duration key and the end of cooking key simultaneously, then press the +/- keys to set the time. MANUAL OPERATION To start cooking without setting end of cooking time, press the manual key . SETTING ONLY THE DURATION OF COOKING IN SEMI-AUTOMATIC MODE To set the duration of cooking, press the duration key and press the +/- keys to set the duration of cooking. A buzzer sounds when the cooking period finishes, and the oven switches itself off.
THE CONTROL PANEL The panel shown here is purely indicative and may not be identical to the panel on the oven you have purchased. Depending on the model of oven you have purchased, the cooking functions and temperature functions may be controlled by knobs instead of keys. The functions themselves are the same for keyboard and knob control ovens.
THE FIRST TIME YOU USE THE OVEN Three zeroes flash on the display the first time you connect the oven to the mains electricity supply, and every time power returns after a power failure. This warns you that you must set the time on the clock before you can select any cooking function. ! You must set the time on the clock before you can use the oven. · Setting the clock Press the two keys shown below simultaneously to enter clock mode.
· Cooking functions For each cooking function, your new oven’s electronic controller suggests a default cooking temperature. This is based on our own experience in obtaining the best results. You can nevertheless change the default value to suit your own requirements.
· Cooking You can start cooking in just a few simple moves. Switch on the oven. Choose which cooking function you want to use. Change the default temperature if you wish, or just wait 4 seconds to accept the default temperature. After 4 seconds the electronic controller automatically switches on the oven. The degrees centigrade symbol flashes to show that the oven is warming up. The cooking time symbol appears on the display to show that the oven is working.
· Using the oven light The oven is equipped with an intelligent light control to reduce electricity consumption. The light stays on while the oven is warming up and for 3 minutes after set temperature is reached, and then switches off. Press any key to check on the food in the oven. The light comes on for another 3 minutes. · Child lock Your new electronic oven has a child lock function to prevent young children from tampering with it or accidentally switching it on.
! Important! You must deactivate the child lock before you can use the oven again. Deactivating the child lock Press and hold the “On/Off” key for at least 3 seconds. The time display shows followed by · Using the time display 1.Using the countdown timer The countdown timer works independently of all other timer functions, and can be used as a practical timer with buzzer even when the oven is switched off.
The normal time display returns with the countdown symbol to show that the countdown is running. At the end of the countdown time the oven beeps twice at an interval of two seconds and the countdown symbol flashes. Press any key to silence the buzzer. The oven beeps three times and the countdown symbol disappears. 2. Setting cooking time Use the cooking time function to set the duration of cooking starting from the present time.
At the end of the cooking time the oven beeps twice at an interval of two seconds and the symbols flash. Then the temperature display, the time display and the heating elements switch off. Press any key to silence the buzzer. The oven beeps three times and the symbols disappear. ! If you select no other functions within 8 seconds from silencing the buzzer, the oven automatically switches off. 3.
The normal time display returns with the auto-timer cooking symbol to show that the oven is working. At the end of cooking time the oven beeps twice at an interval of two seconds and the symbols flash. Then the temperature display, the time display and the heating elements switch off. Press any key to silence the buzzer. The oven beeps three times and the symbols disappear. ! If you select no other functions within 8 seconds from silencing the buzzer, the oven automatically switches off. 4.
Place the dish in the oven and select the cooking function you want (Grill + fan shown by way of example only). Adjust the default temperature as required. Set a cooking time of 30 minutes. Set the cooking time (see section 2. Setting cooking time). Before you set end of cooking time, note the present time. When you set end of cooking time, the timer display present time plus cooking time by default. Use the “+” key to set a time e.g. 10 minutes later. The timer registers this time after a few seconds.
At 12:25, the oven switches on in Grill + fan mode for 30 minutes, and switches off at 12.55 according to our time settings. ! Hint! This is a good time to activate the child lock to prevent young children from tampering with or accidentally switching on the oven.
REPLACING THE OVEN LIGHT IMPORTANT: The oven light must have these precise features: a) it must be able to resist high temperatures (up to 300°C) b) power supply: see V/Hz indicated on data plate. c) power 25W. d) E 14 connection. Before proceeding, disconnect the appliance from the main electricity supply.
INSTALLATION INSTRUCTIONS Flush fitting The oven can be installed under a work top or in a cooking column. Figure shows the installation dimensions. Make sure that surrounding materials are heat resistant. Align the oven centrally with respect to the side walls of the units surrounding it and fix it in place with the screws and Allen screws provided. See the accompanying instructions for combining the oven with multi-functional gas or gas-electric cookers.
ELECTRICAL CONNECTIONS Before connecting the oven to the mains power supply, make sure that: - The supply voltage corresponds to the specifications on the data plate on the front of the oven. - The mains supply has an efficient earth (ground) connection complying with all applicable laws and regulations. Correct earthing (grounding) is a legal requirement.
The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or copying errors. We reserve the right to make on our own products those changes to be considered necessary or useful, without jeopardizing the essential characteristics. COD. 2.000.74.
TIMER TOUCH CONTROL Setting the clock Figure 1 “Auto” and “0:00” will start flashing when the unit is switched on for the first time. To set the clock, press the central button for about 3 seconds. When appears, press “+” or “-“ to set the correct time. Wait until a beep tells you that the clock has been set (figure 1). To set the time at a later stage, press “+” and “-” together for 3 seconds and then adjust the clock as described above.
End of cooking time Figure 4 The end of cooking time can also be set. Press the central button for 3 seconds. Press the central button twice consecutively and wait for “End” to appear (figure 4). Press “+” and “-” to set the required end of cooking time. The oven will work in the set mode and at the set temperature until the end of cooking time. Programming automatic cooking Figure 5 Cooking function with set times. Press the central button for 3 seconds. Then press it again until “dur” appears.
