Instruction manual for in colu olumn wine cabinet Model code: WC6112 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.
Thank you for buying your new Caple Wine Cabinet. To ensure that you get the best results from your new purchase, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains installation advice, usage instructions and other important facts about your CAPLE Wine Cabinet. If treated with care your CAPLE Wine Cabinet should give you many years of trouble free use.
INSTALLATION INSTRUCTIONS BEFORE TURNING THE WINE CABINET ON ENSURE IT IS PERFECTLY LEVEL. This will minimise any vibrations. Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the back feet to the maximum and then use the front feet to level the cabinet. IMPORTANT: WAIT 12 HOURS BEFORE TURNING THE WINE CABINET ON FOR THE FIRST TIME. Safety Instructions • A fan evacuates heat via the bottom vents. • It must be installed well away from any heat source.
OPERATING YOUR WINE CABINET AND SETTING THE TEMPERATURE CONTROL The wine cabinet should be placed where the ambient temperature is between 5-32 deg centigrade. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate and maybe can not reach the setting temperarture. The controls of your Wine cooler LCD touch panel.
Setting The Temperature Controls • The temperature range can be set as low as 4°C or as high as 18°C to suit your specific storage requirements. • The standard temperature setting is 12°C. • When setting the temperature each press on the or button the temperature setting will increase or decrease by 1°C. When the temperature setting reaches the upper limit 18ºC or lower limit of 4ºC, the temperature setting will not increase or decrease.
Storage diagram Total: 22 bottles(Max) (for 750 ml Bordeaux bottles) Shelves • • • To prevent damaging the door gasket, make sure the door is fully opened when pulling shelves out of the rail compartment. For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent bottles from falling.
• ， This shelves are designed with concave grooves Tall wine bottles can also be stored crossways on the wooden shelves. ！ COUTION Do not store bottles crossways on the interior floor! Otherwise, bottles may fall out when the appliance door is opened and this may cause injury or material damage. How to change the door opening This appliance has reversible doors but is delivered with a right hinged door.
1. Incline the wine cabinet with 45 degrees, take out right lower hinge’s screws with screwdriver (Fig.1) 2. Level the wine cabinet, Hold the door and take out right upper hinge’s screws with screwdriver, then take out the door and rotate the door 180 degrees (Fig.2 & Fig.3 & Fig.4) 3. Take off the decorated nail from left upper side, then fit the door with screws, then fit the decorated nail to right side of A location. (see Fig.5& Fig.
Installation specifications for built-in purposes 1. After installing the wine cellar into the cabinet, please adjust limited block (a) close to cabinet (b) 2.
CARE AND MAINTENANCE Cleaning • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about two tablespoons of baking soda to one litre of water. • Wash the shelves with a mild detergent solution. • Wring excess water out of the sponge or cloth when cleaning the control panel, or any electrical parts. • Wash the outside cabinet with warm water and mild liquid detergent.
PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM Wine cabinet does not operate. Wine cabinet is not cold enough. Turns on and off frequently. The light does not work. Vibrations. The Wine cabinet seems to make too much noise. The door will not close properly. POSSIBLE CAUSE Not plugged in.
DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates. HUMIDITY MAINTENANCE SYSTEM The wine cellar is equipped with a system for maintaining the correct level of humidity.
