Instruction manual for in-column wine cabinet Model code: WC6115 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.
WARNING z z z To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. The appliance must be positioned so that the plug is accessible. Release the power cord. Move your cabinet to its final location. Do not move your Cabinet while loaded with wine. You might distort the body. The wine cellar should be installed in a suitable place in order to avoid touching the compressor with the hand.
INSTALLATION INSTRUCTIONS ¾ Before Using Your Wine cabinet • Remove the exterior and interior packing. • Before connecting the Wine cabinet to the power source, let it stand upright for approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • When disposing your appliance, please choose an authorized disposal site.
OPERATING YOUR WINE CABINET AND SETTING THE TEMPERATURE CONTROL Please use the cabinet within an ambient temperature of 5-32 °C. If the ambient temperature is higher or lower than this, it will cause temperature fluctuations in the cabinet. ¾ Controls This is the LCD touch control panel. r e w o P • “Power” When the indicator light is on, the power for the machine is on. • “ ” This shows the temperature of the internal cabinet.
¾ Setting The Temperature Controls • The temperature range can be set as low as 4°C or as high as 18°C to suit your specific storage requirements. • The factory temperature setting is 12°C , and the time is 12:00. • When the system enters the temperature set up. Each press once the or button, will increase or decrease the temperature by 1°C. When the temperature setting reaches the upper limit 18ºC and lower limit 4ºC, the temperature setting will not increase or lower.
¾ Storage diagram Total: 46 bottles (Max) (for 750 ml Bordeaux bottles) r we Po ¾ Shelves • • • To prevent damaging the door gasket, make sure you have the door fully opened when pulling shelves out of the rail compartment. For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent bottles from falling.
CAUTION！ Do not store bottles crossways on the interior floor! Otherwise, bottles may fall out when the appliance door is opened and this may cause injury or material damage. ¾ How to change the door opening This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit.
1. Incline the wine cabinet with 45 degrees, take out right lower hinge’s screws with screwdriver (Fig.1) 2. Level the wine cabinet, Hold the door and take out right upper hinge’s screws with screwdriver. Then take out the door and rotate 180 degrees (Fig.2 & Fig.3 & Fig.4) 3. Take off the decorated nail from left upper side, then fit the door with screws, fit the decorated nail to right side of A location. (see Fig.5& Fig.
1. After installing the wine cellar into the cabinet, please adjust the limited block (a) close to the cabinet (b) 2. Please fix the 3 screws through the limited block (a) to fix to the cabinet (b). See the below picture for reference.
CARE AND MAINTENANCE ¾ Cleaning Your Wine cabinet • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. • Wash the shelves with a mild detergent solution. • Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM Wine cabinet does not operate. Wine cabinet is not cold enough. Turns on and off frequently. The light does not work. Vibrations. The Wine cabinet seems to make too much noise. The door will not close properly. POSSIBLE CAUSE Not plugged in.
DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates. HUMIDITY MAINTENANCE SYSTEM The wine cellar is equipped with a system for maintaining the correct level of humidity.
