Instruction manual for Slot-in Wine cabinet Model code: Wi6125 Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.
WARNING z z z To prevent damaging the door gasket, make sure you have the door all the way open when pulling shelves out of the rail compartment. The appliance must be positioned so that the plug is accessible. Release the electric cord, move your cabinet to its final location. Do not move your cabinet while loaded with wine, you might distort the body. The wine cellar should be installed in a suitable place in order to avoid touching the compressor with the hand.
INSTALLATION INSTRUCTIONS ¾ Before Using Your Wine cabinet • Remove the exterior and interior packing. • Before connecting the Wine cabinet to the power source, let it stand upright for approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • When disposing your appliance, please choose an authorized disposal site.
OPERATING YOUR WINE CABINET AND SETTING THE TEMPERATURE CONTROL Please use the cabinet within a ambient temperature of 5-32 C, if the ambient temperature is higher than or lower than this, it will cause a temperature fluctuation in the cabinet, and may prevent it reaching 5-18 C. ¾ Controls z z z z z z z z z “Light” Button Control the interior light ON/OFF Run When it’s ON, the cooling system runs. “Power” Button Turns this appliance turn on/off.
¾ Note • If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine cabinet will not start. • When you use the Wine cabinet for the first time or restart the Wine cabinet after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to the length of the activation time.
1. When open the door 90 degree, take out 2 screws (2) from lower door axis (3), remove the door (4), then pull out the door and door axis (Fig. A). 2. Put the door (4) safety and take out the plug (12) from top of door frame, unscrew 1 screw (11) at bottom and remove the Door limit device (10), then install the Door limit device (10) at top of door frame, please use spare plug (12) to block the hole at top of door frame. (Fig. A/B) 3. Take out 3 hinge screws (6) from top hinge (right) (5) and remove it.
¾ Installation dimensions CARE AND MAINTENANCE ¾ Cleaning Your Wine cabinet • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. • Wash the shelves with a mild detergent solution. • Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
PROBLEMS WITH YOUR WINE CABINET? You can solve many common Wine cabinet problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM Wine cabinet does not operate. Wine cabinet is not cold enough. Turns on and off frequently. The light does not work. Vibrations. The Wine cabinet seems to make too much noise. The door will not close properly. POSSIBLE CAUSE Not plugged in.
DEFROSTING/CONDENSATION Your wine cellar is designed with an “Auto-cycle” defrost system. When the RUN cycle is OFF, the refrigerated surface of the wine cellar (interior rear wall) defrosts automatically. The defrost water is channelled into a drain pan which is located at the back of the wine cellar next to the compressor from where it evaporates. HUMIDITY MAINTENANCE SYSTEM The wine cellar is equipped with a system for maintaining the correct level of humidity.