User Manual

1. Tips for Brewing the Best Espresso
● To extract the fullest flavor from your beans, we recommend using whole
coffee beans that have been freshly ground each time espresso is prepared.
● In addition to the coffee used, using fresh cold water that is free of chlorine
odors and other impurities will help ensure the perfect espresso.
● Store your espresso grounds in an airtight container, and in a cool, dry place
to retain the flavor. Grounds should not be kept for long periods of time as
the flavor will be reduced.
● Do not fill your filter holder to the brim. Using the measuring spoon included,
use 1 level spoon of grounds per shot of espresso.
● If you do not use the machine for more than 5 consecutive days, rinse and
drain the water tank.
● Before removing the water tank to fill or empty it, always turn the machine off.
● Always place the unit on a flat, stable, heat-resistant work surface.
● To ensure your espresso stays at optium temperature, we recommend that
you preheat your cups.
● If 5 lights are all flashing during brewing, this is a warning instruction. Please
check if water is empty or steam knob is not in closed position.
● Before brewing, the filter holder must be turned to the right as tight as
possible to prevent the filter holder from loosening due to high pressure.
2. Before Using for the First Time
After carfeully unpacking your Ultima PRO, wash all removable parts with warm
soapy water and rinse thoroughly. Familiarize yourself with the appliance and
read the entire instruction manual. Plug the power cord into a grounded wall
outlet according to the safety instructions. Rinse the internal components
before making espresso as described below in chapter 2.1.
2.1. Priming the Machine
a. Open the lid and remove the water tank by lifting up on the handle.
b. Fill the tank with water following the MIN and MAX markings.
c. Replace the water tank by pushing down firmly, to ensure the tank is
properly engaged (Fig. 3), and close the lid.
d. Press the Power button (Fig. 2, C) to turn the machine on. The Power
indicator light will flash while the machine heats up.
e. Insert the portafilter (Fig 1, J), without any coffee. Align the portafilter at the
inscription "▼", push the portafilter up and turn it firmly to the right until it
feels tight.
Note: In the beginning it might not be possible to turn the portafilter all the
way to the “LOCK” position. Just make sure the portafilter is firmly placed.
Over time the portafilter can be moved closer to the "LOCK" position.
f. Place a container under the portafilter large enough to hold all the water in
the water tank.
g. Once the machine reaches the correct temperature, the "Power" light stops
blinking and all 4 product lights illuminate (Single Cup, Double Cup, Hot Water,
and Steam).
6.