froth control Automatic Milk Frother & Hot Chocolate Maker Visit www.capressoblog.
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: • Read all instructions before operating the appliance. • After having the packaging removed, check that the appliance is intact. If in doubt do not use the appliance and contact your sales agent. • The parts of the packaging, plastic bags etc. must not be left within the reach of children as they are potential sources of danger. • DO NOT touch hot surfaces.
SPECIAL CORD SET INSTRUCTIONS Regarding your Cord Set: A. A short power-supply cord (or detachable power-supply cord) is provided to reduce risks resulting from becoming entangled in or tripping over a longer cord. B. Longer detachable power-supply cords or extension cords are available and may be used if care is exercised in their use. C.
HOW TO REACH CAPRESSO Should you require further information or if particular problems occur that are not covered in this manual, please • CALL our toll free HELP LINE: 1-800-767-3554 Monday -Thursday 8AM to 9PM, Friday 8AM to 8PM and Saturday 9AM to 5PM Eastern Standard Time. • FAX us at 1-201-767-9684 • E-MAIL us at contact@capresso.com • VISIT our website at www.capresso.com Lid Fig.
Using the froth Control The froth Control Automatic Milk Frother & Hot Chocolate Maker comes equipped with a milk pitcher with lid, two frothing disks, one heating disk and the base unit. One of the disks is installed inside the milk pitcher. The other disk and the heating disk are stored underneath the base of the appliance. Before First Use Clean the milk pitcher and the disks under running warm water. Make sure the underside of the milk pitcher is completely dry.
A B D C E F Using the Selector Dial The selector dial (F) will control the speed of the disk in the pitcher while the frothing or heating disk will control the milk texture of the frothed or heated milk. There is no right or wrong way to use the frothing or heating disks combined with the different settings on the selector dial. The below chart is a helpful guide, but individual results will vary depending on the type of milk used and different ingredients that are added during the frothing cycle.
Hot Frothing and Heating Milk Perfect for hot beverages such as cappuccinos, lattes, hot chocolate, flat whites and milk steamers. 1. Plug in appliance. 2. Remove lid from milk pitcher. (A) 3. Place one of the frothing disks or the heating disk into the bottom of the milk pitcher. Ensure the disk is completely snapped in. (B) 4. Make sure underside of the milk pitcher is dry. 5. Pour fresh cold milk into the milk pitcher (C) and replace lid. (D) 6. Place pitcher on heating platform. (E) 7.
4. After a few minutes, the appliance will automatically shut off. The indicator light turns off and frothing stops. A short beep will indicate that the end of the cycle has been reached. The cycle can always be stopped manually by pressing the center of the selector dial or lifting the pitcher from the base. 5. Pour milk into cup and spoon froth on top. 6. Always unplug from outlet when not in use and before cleaning.
Tips for using the froth Control: • When adding extra ingredients such as chocolate, smaller pieces will melt more easily than larger pieces. “Chocolate chips” commonly found in the baking section of most supermarkets work well. • Always add extra ingredients along the edge of the pitcher, away from the rotating disk. • Always add extra ingredients gradually to help avoid interrupting the cycle.
Recipes Orange Crème Latte 2 servings • 8-oz low fat milk • 1-2 tsp vanilla syrup • 8-oz orange juice • shaved ice for serving Insert the frothing disk, add milk and vanilla syrup to frothing pitcher and choose the (COLD) FROTH setting. Start the cycle by pressing the center of the selector dial. Wait for the froth Control to automatically shut off. Place shaved ice into the glasses and fill half way with orange juice. Pour frothed milk on top and stir.
Deluxe Caramel Latte 2 Servings • 14-oz milk • 2 shots of espresso or 4-6 oz of strong brewed coffee • caramel sauce • whipped cream Prepare 2 shots of espresso or 4-6 oz of coffee and set aside. Insert the heating disk add milk to the frothing pitcher and choose the FLAT setting. Start the cycle by pressing the center of the selector dial. While the milk is heating coat the inside of two cups with the caramel sauce and divide the prepared coffee evenly between the two cups.
JURA Inc. 20 Craig Road, Montvale, NJ 07645 Tel: 800-767-3554 Fax: 201-767-9684 contact@capresso.com www.capresso.
