User's Manual

2
eg : ADDPHONE3 88888888 [phone] (this is loaded as Ph. # 3)
LOADING the SIMCARD PHONE NUMBER
Most SIMCARDS do not have a phone number stored internally, so you need to load the number assigned to the SIMCARD
by the network provider. Do this by sending RAMV the following command:
DEVPH<>+(country code)(area code)(SIMCARD phone number)
eg: DEVPH [phone]
If you don’t add the Device Phone number, RAMV will still work, but the TIME will not be updated from the network
.
LIST REGISTERED PHONES
To check the four recipient phone numbers stored in RAMV. Send the following command:
GETPHONE
REMOVING a PHONE NUMBER
Send the following text to your RAMV
REMOVEPHONEn <>PASSWORD<> +(country code)(area code)(phone number) (n is ph # 1 to 4)
eg: REMOVEPHONE2 <>88888888 [phone] ( this removes ph # stored as #2)
To change a number, you can load the new number over the old using ADDPHONE. If there is no room left, RAMV will
advise with a message.
CHANGING PASSWORD
To change the password, send RAMV the following text message;
PASSWORD<>OLD password<>NEW password
eg: PASSWORD 88888888 12345678
SETTING and USING the GEO-FENCE
From your cellphone, send RAMV the following Geo-Fence command:
'SET'
It will respond with a confirmation SMS that it has a new HOME location for the geo-fence.
That’s all…. RAMV will now send a transgression report if it moves outside the geo-fence radius.
Nothing other than external alarms will be sent while within the new Geo-fence zone. It will of course be
monitoring any bilge levels or security devices all the time. You can at any time send commands and receive