User's Manual

Regarding JBP, please see as follow information

"JBP" is the equipment class code assigned by the Commission to designate Part 15 Class B

Computing Device Peripherals on FCC Form 731

FCC Compliance

Section 15.21 Information to user

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment

Section 15.19 Labeling requirements:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired operation.

Section 15.105 (b)

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

--Consult the dealer or an experienced radio/TV technician for help.

IMPORTANT NOTE:

To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter

must be installed to provide a separation distance of at least 20 cm from all persons and must not

be co-located or operating in conjunction with any other antenna or transmitter”

NOTE:

RAM accepts no liability for the applications or uses made by its products. We recommend that you always

obey local laws relating to tracking and in particular disablement of vehicles by remote control. This can be

dangerous and should not be deployed on road vehicles as it can cause serious injury to others. Only

activate remote engine kill when you have the vessel in sight and it is safe to do so. RAM also accept no

liability for the use or misuse of its products under any circumstances, including GSM network, GPS services,

or device failure, for whatever reason.

RAM also reserves the right to change the specifications, functionality and instructions of its products and

accessories, at any time without notification. Thank you for purchasing your RAMV.

END.