User Manual

25
Step 2: Create a WIFI hotspot on the phone the first time and go to WIFI in the radio and connect to
the phone.
Step 3: Go to the Zlink application and connect the phone via the USB cable. Make sure your iPhone
has SIRI and SEARCH turned on.
Then, after a notification you get at the first startup, press wired CP and Android auto. After this you
can give permission for car play and or Android auto in the phone by means of a pop up.
Note with an Android phone it is important that you also have Android auto on the device. You can
read this back via the steps on the previous page.
If car play or Android auto does not open, you can go to ABOUT MORE FUTURES click wired CP/ AA
authenticate refresh refresh
If you still cannot connect, you can turn off your hotspot and try connecting it again after plugging in
the USB again.
iPhone cards app does not emit sound:
On the phone, go to apps settings – application maps – sounds and navigation and turn on the voice/
route guidance on and at high volume
In addition, you can also adjust the choice between switch and mixing when reproducing sound via
settings – car settings or car infotainment under the navigation heading.
You can also use the MAPS application to test whether the sound works. If this is the case, please
refer to the map’s application settings again.
Adjust volume balance:
You can go via settings – system or car settings to the factory settings of the device This can be done
via 3368 | 126 or 8888 (depending on the device)
Then you can turn up the sound of the system with voice (this includes the applications) and then you
can also set / adjust the sound level of other sources if necessary.