User Manual

6
360
o
view camera: these are cameras, one front, one rear, one left, one right and have 360
o
display.
If your car has the 360
o
view camera from the factory, then the advice is to have a multimedia with
WDR support.
Factory reset
You can go to the factory settings of the device via settings – system or car settings. This can be
done via 123456/3368/12345/1234/126/8888/88888/1617/66666 (depending on the device)
General tips when installing a car stereo
(De-energize the car before you start installing)
Installation
- remove any adapter plugs so that you can use the
New cables can be mounted on the original connections.
- If there is a DVD player in the radio, remove the transport screws.
- Never press the screen to get the radio into the car during installation. There should be sufficient
space at the rear of the system. Make sure that no cables get stuck between your car and the
system.
Radio does not automatically turn on/off on contact.
If the radio does not turn on, it will not receive power. This is because there is no 12 volts coming in.
The red ACC wire is the power wire of the radio, and it must be equipped with contact power (so that
this wire gets power when the ignition is on and does not get a power supply when the contact is
off). The yellow wire must be provided with a constant power supply. This wire ensures that the
radio remembers its memory (battery / B +).
Note that if you have a can bus decoder, it is also linked to the white plug of the connector. If the
radio does not turn off, the acc red wire receives a constant power supply. This is not the intention
because it will slowly drain your battery. With various ready-made radios you can disconnect a black
connector with two wires, which can then be the solution so that the radio does turn on / off on
contact. If the plug and play plug does not have this plug, you can reverse the red acc wire with the
battery/B+ wire.
Names of plugs (not every radio/navigation has a can bus decoder) Quad
lock plug GPS antenna CANBUS Decoder Iso plug.
Quick start manual installation ready-made system (brief
explanation)
Make sure your car is power-free when you start installing
1. Pair the main plug between your car plug and the
Radio. Make sure you put the can bus on the white plug
Decoder pairs. It may be that there is still a small